Extreme Networks ExtremeWare XOS Command Specifikace stáhnout pdf (Strana 400)

100

101

400 ExtremeWare XOS 10.1 Command Reference Guide

STP Commands

show stpd

show stpd {<stpd_name> | detail}

Description

Displays STPD settings on the switch.

Syntax Description

Default

N/A.

Usage Guidelines

The command displays the following STPD information:

• STPD name

• STPD state

• STPD mode of operation

• Autobind mode

• Rapid Root Failover

• Tag

• Ports

• Active VLANs

• Bridge Priority

• Bridge ID

• Designated root

• STPD configuration information

You can create, configure, and enable one or more STP domains and use the show stpd command to

display STP configurations. Use the

create stpd command to create an STP domain. Use the enable

stpd

command to enable an STPD. If you have considerable knowledge and experience with STP, you

can configure the STPD using the

configure stpd commands. However, the default STP parameters

are adequate for most networks.

Example

The following command displays STPD settings on an STPD named Backbone_st:

show stpd backbone_st

The following is sample output from this command:

Stpd: backbone_st Stp: ENABLED Number of Ports: 51

stpd_name Specifies an STPD on the switch.

detail Specifies that STPD settings should be shown for each STPD.

1 2 ... 395 396 397 398 399 400 401 402 403 404 405 ... 757 758

Komentáře k této Příručce

Žádné komentáře

Extreme Networks ExtremeWare XOS Command Specifikace Strana 400

Komentáře k této Příručce