Extreme Networks WM-4T1i Specifikace Strana 31

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 306
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 30
Extreme Networks Consolidated Hardware Guide 1-5
Mini-GBIC Type and Hardware/Software Support
Note: If you see an amber blinking mini-GBIC port status LED after you install a
mini-GBIC into the Summit24e3 or Summit48si switch, this means the mini-GBIC
is not certified by Extreme Networks. To correct this problem, install an Extreme
Networks certified mini-GBIC, available from Extreme Networks, into the port in
the switch.
Preparing to Install or Replace a Mini-GBIC
To ensure proper installation, complete the following tasks before inserting the
mini-GBIC:
Disable the port that is needed to install or replace the mini-GBIC.
Inspect and clean the fiber tips, coupler, and connectors.
Prepare and clean an external attenuator, if needed.
Do not stretch the fiber.
Make sure the bend radius of the fiber is not less than 2 inches (5.08 cm).
When installing or replacing mini-GBICs on an active network, use the same type of
mini-GBIC at each end of the link.
Once you complete all of these tasks, you are ready to install or replace a mini-GBIC.
Installing and Removing a Mini-GBIC
You can add and remove mini-GBICs from your Summit24e3 switch without powering
off the system. Figure 1-1 shows the mini-GBIC connector.
Zobrazit stránku 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 305 306

Komentáře k této Příručce

Žádné komentáře