
5-6 Extreme Networks Consolidated Hardware Guide
Summit Switch Installation
4 To turn the power supply on, connect the AC power cable to the power supply and
then to the wall outlet.
Warning: Do not plug in the power cord into the power supply unless the power
supply is installed.
5 Keep the faceplate and the power supply packaging for future use.
Installing an AC Power Cord Retaining Bracket
To install an AC power cord retaining bracket:
1 Disconnect the power cord from the switch and the power source.
2 Remove the two retaining screws from the power socket on the rear of the switch
using a #2 Phillips screwdriver.
You will not re-use these screws.
3 Slide the retaining bracket over the power cord, as shown in Figure 5-5. If necessary,
loosen the retaining bracket screw.
Figure 5-5: Attaching the retaining bracket to the power socket
SH_001
Retaining bracket screw
Komentáře k této Příručce