Extreme Networks Altitude 4700 Series Specifikace Strana 410

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 648
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 409
CLI Reference
Altitude 4700 Series Access Point Product Reference Guide
410
admin(network.wireless.radio.802-11n[5.0 GHz])>set rts 2341
admin(network.wireless.radio.802-11n[5.0 GHz])>set range 40
admin(network.wireless.radio.802-11n[5.0 GHz])>set qbss-beacon 110
admin(network.wireless.radio.802-11n[5.0 GHz])>set qbss-mode enable
admin(network.wireless.radio.802-11n[5.0 GHz])>set single-antenna disable
admin(network.wireless.radio.802-11n[5.0 GHz])>set dynamic-chain-selection enable
admin(network.wireless.radio.802-11n[5.0 GHz])>set tkip-ht-compatibility disable
admin(network.wireless.radio.802-11n[5.0 GHz])>set bcmc-tx-speed range
CAUTION
A 40 MHz channel is composed of two 20 MHz subchannels. If the firmware detects radar within the FCC
80 % detection band of the 40 MHz channel; the device must vacate the channel. If the detected signal falls outside
the FCC 80 % detection band of one of the 20 MHz subchannels; the Master Device can legally move to that 20
MHz channel.
For information on configuring the Radio 2 Configuration options available to the access point using the
applet (GUI), see “Configuring the 802.11a/n or 802.11b/g/n Radio” on page 174.
Zobrazit stránku 409
1 2 ... 405 406 407 408 409 410 411 412 413 414 415 ... 647 648

Komentáře k této Příručce

Žádné komentáře