Extreme Networks e" series Instalační příručka Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 112
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
Evaluating and Meeting Cable Requirements
Consolidated "e" Series Hardware Installation Guide 27
Figure 1: Properly secured rack (SPG_007 redraw with e series in the rack)
Brace open distribution racks if the channel thickness is less than 1/4 inch (6.4 mm).
Evaluating and Meeting Cable Requirements
This section addresses requirements for the that cable you should use when installing your network
equipment. It includes:
Cabling Standards
Cable Labeling and Record Keeping
Installing Cable
RJ-45 Connector Jackets
Radio Frequency Interference
Cabling Standards
We recommend using the BICSI (Building Industry Consulting Service International) RCDD (Registered
Communications Distribution Designer), which is globally recognized as a standard in site planning and
cabling. For information, go to http://www.bicsi.org
SPG_00
7
Secure to floor
with 3/8 inch lag screws or bolts
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 111 112

Komentáře k této Příručce

Žádné komentáře